What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 03:42

The bolt then partially travels down the line to your home.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–14 [Omar Gharbi Omar Gharbi ]
(Dc diagram shown, AC is similar).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Wing and Walmart are bringing drone delivery to 100 new stores - The Verge
This is where this question deviates from being a 'generic' question, and becomes more specific.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
the problem then depends on "how fast does the fuse operate?".
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At least they know the answer if they wanted it.
Why do women have sex with dogs?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–16 [ OO OLAOYE OYEBODE ]
There are two important concepts here.
What is a good comeback for when someone calls you flat?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
so, what happens?
But it can get overloaded, and no longer works.
Man accused of writing Trump assassination letters was framed, officials say - BBC
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Upvotes:
At least 32 Zotac RTX 5090 buyers at Micro Center find only backpacks inside the boxes - TechSpot
Here is a simplified AC power diagram.
A fuse is a non-resetable over current circuit protector.
This is 'the assistant's answer'
Edit 2024–10.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
He then describes Rainy Season and Lightning.
Circle’s buzzy IPO was a big hit. Now comes the hard part. - MarketWatch
The other is “what does a “fuse” do?”
what exactly is a ‘surge’ protector?
This is where the MOV conducts again, and dissipated the energy.
Debunking 5 myths about when your devices get wet - The Conversation
So, the voltage could go up to 500 volts, and the fuse will not open up.
This one hit behind the barn.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
How do the youth in Taiwan perceive their national identity in relation to China?
He then asserts :
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
[image of Common-mode choke]
Largest Horned Dinosaur Ever Found Looks Like It Walked Off a Marvel Set - Indian Defence Review
These devices are installed between the “hot” and “neutral” and protective ground.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
In schematic diagrams this is the symbol for a fuse:
Were you ever in love with your teacher?
For this case there are devices called Metal oxide varistors (MOV).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
These are simplified answers to the original question, and does not change anything I wrote above.
A circuit breaker is similar, but is resettable.
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
[old diagram got deleted by accident]
This device then solves the entire problem.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
but this device (an Inductor) … impedes the rapid changes in the current.
One
First Sentence:
One is “what exactly is in a ‘surge protector’ ? ”
At one ohm, the resistor has a maximum of 1 watt power.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Because the load is inductive, the current lags the voltage.(by a bit).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What is lightning?
An AC voltage/ current source, and an ac inductive load.
What does a fuse do?
Now when you have a certain ac resistance, then a current flows in a loop.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
a photo is worth a thousand words.
nine
but I think this circuit , shows a few more pieces.
Barnstars:
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
I post the exact comment here.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It seems Mohan does not understand the difference between a comment and an Answer.
There are three different concepts here that are getting confused.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
It also is a device that limits the change in current flow.
The third is lightning and “how it gets conducted into a home.”
He then describes the function of a fuse.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
eight
2024–10–10[John johnson John Johnson ]